![]() ![]() That’s all there is to it! I hope this post was informative and that you were able to resolve the problem you were facing.A keyless door lock spinning can compromise your property's safety. However, if the issue persists, contact Schlage Custom Support for assistance. The troubleshooting techniques listed above should help you fix your Schlage keypad lock that has stopped working due to the cold. The next time you try to use your keypad, it should work properly! Conclusion Then, reassemble your device and reconnect your battery pack before putting it back onto your door. Open up each side of your keypad lock and use a small piece of wire to hold down the spring that’s located on the right side of your keypad. Gently pull out each side of your lock and remove it from both sides of your door. Next, remove the battery pack from its housing and disconnect it from the main part of your lock. To do this, first remove the screws on your Schlage keypad lock using a Phillips or Torx screwdriver. Fortunately, you can fix this problem simply by removing your lock from the door, taking it apart and fixing the spring. This is usually caused by an issue with the spring inside the lock. Remove The Lock From The Door And Fix The Springį you’re struggling to enter your password in the cold weather, it’s likely that your Schlage keypad lock is turning off by itself. If you have further problems with your Schlage keypad lock after trying these troubleshooting steps, contact Schlage customer service for help troubleshooting or to find out about replacement options if your lock is no longer under warranty. Test your keypad to see if it’s working properly now if not, try repeating the process with both batteries removed at once, or replacing them together before moving on to testing your keypad again.Take one battery out of the unit and replace it wait 10 seconds then replace the second battery and close everything up again.You should see two batteries underneath-they may look like they’re attached to each other, but they should be separate units that can be moved individually. Carefully lift the circuit board out of place and set it aside.With a screwdriver, remove the two screws on either side of the circuit board.If the keypad continues to be unresponsive, you should try resetting the lock to see if it solves the problem. Reset The LockĪny electronic faults with a Schlage keypad lock may typically be resolved by doing a factory reset. If this doesn’t fix the problem, move on to our next tip. Once you have done that, replace the batteries and test the keypad again. The next thing to do is to remove the outer cover of the lock and remove the inner cover so that you can access the battery compartment. This is because rechargeable batteries lose power in a cold environment and may not be able to function properly. If you have been using rechargeable batteries, try replacing them with new Alkaline batteries. The Schlage keypad lock uses two AA batteries. This can be a common problem if you haven’t used the keypad in a while or if the lock has been sitting in the sun. If the batteries are low, your keypad lock may not work at all. The first thing you should do is make sure the batteries are fully charged before you try to program your lock. Conclusion Schlage Keypad Lock Not Working When Cold: Try These Troubleshooting Tips.Remove The Lock From The Door And Fix The Spring Schlage Keypad Lock Not Working When Cold: Try These Troubleshooting Tips. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |